Siemens LMV5 Quick Start Manual page 79

Menu Path Parameter
GasFiring
OilStage1/Mod
OilStage2
Operation>
Hours Run
OilStage3
TotalHoursReset
TotalHours
SystemOnPower
GasStartCount
Operation> OilStartCount
Start Counter
TotalStartCountR
TotalStartCount
Curr Flow Rate
Volume Gas
Operation>
Volume Oil
Fuel Meter
Volume Gas R
Volume Oil R Volume Oil R
Reset DateGas
Reset DateOil
Operation LockoutCounter
Current O2 Value
O2 Setpoint
Operation>
SupplyAirTemp
O2 Module
FlueGasTemp
CombEfficiency
Operation BurnerID
InterfacePC
Operation>
GatewayBASon
OptgMode Select
GatewayBASoff
Type of Gateway
LMV5 QSG Rev 4
U = User O = OEM
S = Service
Hours run on gas. Reset / adjust: Params & Display > HoursRun > GasFiring
Hours run on OilStage1/Mod. Reset / adjust: Params & Display > HoursRun > OilStag1/Mod
Hours run on OilStage2. Reset / adjust at: Params & Display > HoursRun > OilStage2
Hours run on OilStage3. Reset/ adjust at: Params & Display > HoursRun > OilStage3
Hours run, all fuels. Reset / adjust: Params&Display > HoursRun > Reset >Total Hours Reset
Displays the number of hours run on all fuels. Cannot be reset or adjusted.
Hours the system has been powered. Cannot be reset or adjusted.
Number of startups on gas. Reset / adjust: Params & Display > StartCounter > GasStartCount
Number of startups on oil. Reset / adjust: Params & Display > StartCounter > OilStartCount
Displays the number of Startups on all fuels.
Reset / adjust at: Params & Display > StartCounter > TotalHourR
Displays the number of Startups on all fuels. Cannot be reset.
Displays the current flow rate of fuel, Gas or Oil.
Displays the total Volume of Gas that has entered the burner as calculated by the VSD module. Reset /
adjust: Params & Display > StartCounter > Volume Gas
Total Volume of Oil that has entered the burner as calculated by the VSD module.
Reset / adjust: Params & Display > StartCounter > Volume Oil
U
Displays the Volume of Gas or Oil that has entered the burner since the last reset.
Pressing ENTER will cause these values to be reset. Pressing ENTER will cause these values to be reset
Displays the Date when the Volume of Gas was last Reset. Cannot be changed.
Displays the Date when the Volume of Oil was last Reset. Cannot be changed.
Displays the total number of Lockouts that have occurred.
Current O2 Sensor Reading (Wet basis)
O2 target value for the current load can be viewed here.
Combustion air temperature if equipped with the proper sensors. PLL Module necessary.
Flue gas temperature if equipped with the proper sensors. PLL Module necessary.
A calculated value of the Combustion Efficiency based on the wet O2 value. Supply air temperature a O2
sensor and a flue gas temperature sensor are required for this feature.
Burner Identification. (Mandatory) Adjust at: Updating > BurnerID (requires OEM password)
This places the AZL into the Interface mode making it able to communicate with a PC.
This enables or disables Com 2, the RJ45 jack on the back of the AZL, for ModBus or eBUS communication.
This port uses RS-232 communications.
This parameter configures the protocol of Com 2. Options are ModBus or eBUS
Sec 4 Pg 23
Descriptions / Notes
All
www.scccombustion.com