Table of Contents
Advertisement
Hitachi Gigabit Router GR2000-B Series Installation Guide
Danger
Do not use the GR2000-B if there is smoke or
an unusual smell coming from it. If either
occurs, immediately turn power off and
unplug the power cable from the outlet.
Contact a qualified service technician.
If liquid is spilled on the GR2000-B, turn
power off and unplug the power cable from
the outlet. Discontinue use to avoid the risk
of fire or electric shock.
If a foreign object falls into the router when
the cover is off, turn power off and unplug the
power cable from the outlet. Do not attempt
to remove the object while the power is on.
Do not put the router on an unstable or
uneven place. Put it on a stable and flat surface to prevent it from falling and
causing damage.
When installing the GR2000-B on a desk, lay it down horizontally on it's rubber
feet. If you stand it vertically or lean it against a wall, it could fall down and cause
damage to itself or a person.
Make sure that the router is in a stable, secure position when mounting it into a
rack. If you try to install it without anchoring it to the rack, it could fall out of the
rack.
Do not put a metal object, such as a pin
or paperclip, or a vase or flower pot on the
GR2000-B. Water or object getting into
the chassis could cause a severe electrical
shock to anyone touching the router.
Do not use a power source or voltage that
exceeds the specifications of the
GR2000-B. Observe markings on the chassis.
To prevent electric shock, use only grounded power outlets.
Do not use adapters to connect multiple power cables to the same outlet. Doing
this can cause a fire and can cause a circuit breaker to trip due to an overloaded
circuit.
Do not put a heavy object on a power cable, since it could crush it. Similarly,
don't pull, bend or otherwise mutilate the power cable, since this could cause a
fire or electric shock.
Use the power cable packed along with a chassis. If you use a power cable other
than this, it could cause a fire or an electric shock. In addition, do not use this
power cable for devices other than the GR2000-B. If you do, it could cause a fire
or electric shock.
Do not put a power cable under the device. Doing this might cause a fire or an
electric shock.
If the power cable is ever damaged so that the wires underneath the covering are
visible or cut, stop using it and ask a maintenance staff to replace it. If you
continue to use a damaged cable, it could easily cause a fire or electric shock.
xiv
Remove the cable lock metal, and
unplug the cable.
GR2K-GA-0007
Rev. 5.00
Advertisement
Table of Contents
