Table of Contents
Advertisement
3.3
The Setup Terminal and Cable Connections
3.3.1
Setup Terminal
Prepare a personal computer or a workstation which supports the following features
mentioned in Table 3-15 below.
Table 3-15 Specifications Required for Setup Terminals
Category
Communication port
Communication software
Communication
settings
Other features (Note 2)
Note 1:
Set to default of 9600 bps as shipped from factory.
Note 2:
Used to re-install the software.
3.3.2
Connecting Cable
The RS-232C cable, a cross-cable having a D-sub 9-pin (female) on each end, is
required to connect GR2000-B to a setup terminal. Table 3-16 below shows the pin
arrangement of the RS-232C cable.
Table 3-16 Pinout for RS-232C Cable
No.
Router Side: 9 Pins (Female)
Pin Number
1
2
3
4
5
6
7
8
GR2K-GA-0007
Rev. 5.00
Transfer Protocol
Parameter
Speed in bps (Note 1) 19200, 9600, 4800, 2400, or 1200
Signal Name
5
SG
3
SD
2
RD
7
RS
8
CS
1
CD
6
DR
4
ER
Preparing Interface Cables and the Terminal
Specification
RS-232C
Hyperterminal utility in Windows 95/98 or other similar
terminal communication software.
ZMODEM
8-bits data, 1 stop bit, no parity
CD-ROM drive
Physical Connection
Console Side: 9 Pins (Female)
Pin Number
Signal Name
5
GND
2
RX
3
TX
1
DCD
8
CTS
7
RTS
4
DTR
6
DSR
3-19
Advertisement
Table of Contents
