Table of Contents
Advertisement
Make sure that you have either a NIF in, or dummy panel installed over, an
option slot. If not, air may not circulate correctly inside the router.
For the installation of a network interface board, use a screw driver when
fastening screws and make sure that the screws are fixed firmly, but do not
overtighten.
Take care so that the fan cables, etc. are not snagged or crushed inside the router
when replacing the cover.
Clean the device only with a clean, dry cloth or use a cloth that has been
dampened (not wet) with water or another pH-neutral liquid. Do not use volatile
organic solutions such as benzene or paint thinner, chemicals, chemically
treated cloths or pesticides, which may deform, discolor or damage the router.
Do not place the router in direct sunlight or
near heat sources that may cause damage.
If the router is placed together with a radio
or a TV, they might affect each other in an
unfavorable way. If you hear the burst of
noise on a TV or a radio, do the following:
Place the device as far away from a TV or a
radio as possible.
Turn the antenna of a TV or a radio to
another direction.
Do not use the same outlet as the router.
Unplug the power cable from the outlet when the router is not used for long
periods.
Dispose of exhausted devices or boards, including lithium batteries, as required
by local regulations.
GR2K-GA-0007
Rev. 5.00
xvii
Advertisement
Table of Contents
