Toshiba Satellite 110 Series Maintenance Manual page 126

Installing the Keyboard
To install the keyboard, follow the steps below and refer to Figures 4-11 to 4-14.
1. Connect the keyboard cable to PJ13 on the system board. Make sure the cable
connection is secure in the pressure plate.
2. Fit the two tabs of the metal cover into the top cover and backup battery base
(Figure 4-14). Then seat the metal cover and secure it with five M2.5x6 screws.
Make sure the plastic tab on the LED connector is under the metal cover. Be sure
to replace the ground cable.
3. Fit tabs on the back of the keyboard into corresponding holes on the computer and
lay the keyboard in place.
4. Secure six latches on the back of the keyboard base. Then secure two latches at
the ends and six latches along the front.
5. Install the HDD, optional memory module, optional PC card, and battery pack as
described in Sections 4.5, 4.4, 4.3, and 4.2.
4-16
Figure 4-14 Seating the metal cover
110 Series