Toshiba Satellite 110 Series Maintenance Manual page 66

3.8 Floppy Disk Test
NOTE: Before running the Floppy Disk Test, prepare a formatted work disk. Remove
the Diagnostics Disk and insert a work disk into the FDD. The contents of the floppy
disk will be erased.
To execute the Floppy Disk Test, select 5 from the Diagnostic Test Menu, press Enter, and
follow the directions on the screen. The Floppy Disk Test contains five subtests that test the
internal floppy disk drive. The following messages appear after selecting the Floppy Disk
Test from the Diagnostic Test Menu. To execute the test, answer each question with an
appropriate response.
Select the test drive number of the floppy disk drive to be tested and press Enter.
1.
Test drive number select (1:FDD#1,2:FDD#2,0:FDD1&2) ?
NOTE: The computer supports one FDD, so select FDD#1. The other
options cause an error in the test program.
2. Select the media type of the floppy disk in the test drive to be tested and press
Enter.
Media in drive #X mode (0:2DD,1:2D,2:2D-2HD/2DD,3:2HD) ?
Select the track you want the test to start on and press Enter. Simply pressing
3.
Enter sets the start track to zero.
Test start track
4. The Floppy Disk Test Menu appears after you select the start track number.
Select the number of the subtest you want to execute and press Enter. The
following message appears during the Floppy Disk Test.
FLOPPY DISK
3-20
(Enter:0/dd:00-79) ?
XXXXXXX
xxxx DIAGNOSTIC TEST VX.XX
[Ctrl]+[Break]
[Ctrl]+[C]
; test end
; key stop
110 Series