Toshiba Satellite 110 Series Maintenance Manual page 33

Procedure 3 Printer Port LED Check on Resume Mode
The printer port LED displays the IRT status and test status by turning lights on and off as an
eight-digit binary value for Resume mode.
To use the printer port LED, follow these steps:
1. Turn the computer on; then set to Resume mode.
2. Turn the computer off.
3. Plug the printer port LED into the computer's parallel port.
4. Turn the computer on.
5. Read the LED status from left to right as you face the back of the computer.
6. Convert the status from binary to hexadecimal notation.
7. If the final LED status is FFh (normal status), go to Procedure 4.
8. If the final LED status matches any of the test status values in Table 2-2, go to
Procedure 5.
Table 2-2 Printer port LED Resume mode error status
Error status
F1H RAM BIOS error.
F2H The system has optional ROM, or optional card (CGA, MDA).
F5H Main memory checksum error.
F6H Video RAM checksum error.
F7H Extended memory checksum error.
110 Series
Meaning
2-15