Toshiba Satellite 110 Series Maintenance Manual page 36

Procedure 2 Diagnostic Test Program Execution Check
The Floppy Disk Drive Diagnostic Test Program is stored on the Diagnostics Disk. After
loading Toshiba MS-DOS, run the Diagnostics Program. Refer to Chapter 3, Tests and
Diagnostics, for more information about the diagnostics test procedures.
Each floppy disk drive test error code and its status is described in Table 2-3. Make sure the
floppy disk in the FDD is formatted correctly and that the write protect tab is disabled. If any
other errors occur while executing the FDD diagnostics test, go to Check 1.
Table 2-3 Floppy disk drive error code and status
Check 1 If the following message displays, disable the write protect tab on the floppy disk.
If any other message appears, perform Check 2.
Write protected
Check 2 Make sure the floppy disk is formatted correctly. If it is, go to Procedure 3.
2-18
Code
01h Bad command
02h Address mark not found
03h Write protected
04h Record not found
06h Media removed on dual attach card
08h DMA overrun error
09h DMA boundary error
10h CRC error
20h FDC error
40h Seek error
60h FDD not drive
80h Time out error (Not ready)
EEh Write buffer error
FFh Data compare error
Status
110 Series