Special Tools - Yamaha MIO Service Manual

EAS00027

SPECIAL TOOLS

The following special tools are necessary for complete and accurate tune-up and assembly. Use
only the appropriate special tools as this will help prevent damage caused by the use of inappropri-
ate tools or improvised techniques. Special tools, part numbers or both may differ depending on the
country.
When placing an order, refer to the list provided below to avoid any mistakes.
Tool No.
Weight
90890-01084
Slide hammer bolt
90890-01085
90890-01184
90890-01186
90890-01189
90890-01235
Compressor
90890-01253
Attachment
90890-01243
90890-01268
Tool name/Usage
Weight
Slide hammer bolt
These tools are used when removing or
installing the rocker arm shafts.
Fork seal driver weight
This tool is used to installing the oil seal.
Fork seal driver attachment
This tool is used to installing the oil seal.
Flywheel puller
This tool is used for removing the A.C.
magneto rotor.
Rotor holding tool
This tool is used to hold the A.C. mag-
neto rotor when removing or installing
the A.C. magneto rotor nut.
Valve spring compressor
Valve spring compressor attachment
These tools are used when removing or
installing the valve and the valve spring.
Ring nut wrench
This tool is used to loosen and tighten
the steering ring nut.
SPECIAL TOOLS
1 - 5
GEN
INFO
Illustration