Yamaha MIO Service Manual page 230

1
2
FRONT BRAKE
9. Install:
• meter assembly cover 1
• left handlebar switch bracket
NOTE:
_
When installing the meter assembly cover,
make sure that the gap between the brake
master cylinder bracket 2 and the meter
a
assembly cover is uniform. If the gap is not
uniform, loosen the bolt in the hole a in the
meter assembly cover and adjust the position
of the brake master cylinder bracket.
10.Connect:
• right handlebar switch coupler 1
• left handlebar switch coupler 2
• meter assembly coupler 3
11.Install:
• speedometer cable 4
12.Tighten:
• rearview mirror nuts (left and right)
13.Install:
• front fender
• collars
• front fender bolts
• front fender screw
6 - 30
Refer to "CABLE ROUTING" in chapter 2.
Refer to "CABLE ROUTING" in chapter 2.
32 Nm (3.2 m · kg, 23 ft · lb)
7 Nm (0.7 m · kg, 5.1 ft · lb)
7 Nm (0.7 m · kg, 5.1 ft · lb)
CHAS