Assembling The Starter Motor - Yamaha MIO Service Manual

a
b
2
STARTER MOTOR
6. Measure:
7. Check:
8. Check:
EAS00772
b

ASSEMBLING THE STARTER MOTOR

1
_
Always use a new O-ring.
1. Install:
3
New
NOTE:
_
Align the match mark a on the starter motor
yoke with the match marks b on the front and
starter motor rear cover.
7 - 24
• brush spring force
Out of specification → Replace the brush
springs as a set.
Brush spring force
5.52 ~ 8.28 N
(563 ~ 844 gf, 19.87 ~ 29.80 oz)
• gear teeth
Damage/wear → Replace the gear.
• bearing
• oil seal
Damage/wear → Replace the defective
part(s).
WARNING
• washer
(to armature)
• armature
(in starter motor front cover 1)
• O-rings
New
(to starter motor yoke)
• starter motor yoke
• starter motor rear cover 2
• starter motor rear cover bolts
(with O-ring and washer)
• O-ring 3
New
(to starter motor front cover)
• starter motor lead
– +
ELEC