Checking The Handlebar; Installing The Handlebar - Yamaha MIO Service Manual

HANDLEBAR
EAS00668

CHECKING THE HANDLEBAR

1. Check:
• handlebar 1
Bends/cracks/damage → Replace.
WARNING
_
Do not attempt to straighten a bent handle-
bar as this may dangerously weaken it.
EAS00673

INSTALLING THE HANDLEBAR

For installation, reverse the removal proce-
dure.
1. Stand the motorcycle on a level surface.
WARNING
_
Securely support the motorcycle so that
there is no danger of it falling over.
2. Install:
• handlebar 1
NOTE:
_
Align the pipe a on the handlebar with the slit
b on the lower bracket.
3. Tighten:
• handlebar nut
4. Install:
• starter cable
• rear brake cable
• throttle cable
• speedometer cable
• wire harness
• front brake hose
Refer to "CABLE ROUTING" in chapter 2.
NOTE:
_
Hook the plastic loop 1 attached to the wire
harness onto the projection on the handlebar
after installing the wire harness.
6 - 42
CHAS
43 Nm (4.3 m · kg, 31 ft · lb)