Table of Contents
Advertisement
DATA PROGRAMMING
Assignment of FCH Related Data
STEP 5: ARTD/ARTDN
Using ARTD, assign the following CDN data for the dummy route number. Note 1
CDN 6 (TCL)=1 or 4 (depending on requirement)
CDN 7 (L/T)=1
CDN 13 (AC)=1
The other CDNs may be left default (data 0) for the dummy route.
STEP 6: AFRSL/AFRSN Note 2
Using AFRSL, assign the Number Pattern Code (NPC) and the Outgoing Route Selection Pattern
Number (OPR) for the dummy route number.
LGRT=Dummy route number
STEP 7: AOPRL/AOPRN Note 2
Using AOPRL, assign the external route number to OPR assigned in the AFRSL command.
TDPTN=0
PRSC=0
TDPTN=0
PRSC=0
STEP 8: AADCL/AADCN Note 2
Using AADCL, assign the additional Digit Code to PNL assigned in the AOPRL command.
PNL=128
DC=12025678901
STEP 9: ARSCN
Using ARSCN, assign the Route Restriction Class (RSC) that allows RRIs for the external trunk
route. The same route restriction data must be assigned for each node.
Note 1:
The dummy route must be assigned to all nodes (including a node which does not have external routes).
Note 2:
When entering the data in STEP 1, 2, 6, 7 and 8, do not mix the commands for LDM and NDM. Write the
data on the same data memory as shown below:
•
When writing the data on the LDM:
ANPDL → ASPAL
(STEP 1)
•
When writing the data on the NDM:
ANPDN → ASPAN → AFRSN → AOPRN → AADCN
(STEP 1)
CHAPTER 5
Page 92
Revision 3.0
NPC=8110
OPR=1
RA=0
E=1
OPR=1
RA=1
E=0
→ AFRSL → AOPRL → AADCL
(STEP 2)
(STEP 6)
(STEP 2)
(STEP 6)
ND-70185 (E)
Get other manuals https://www.bkmanuals.com
OPR=1
LGRT=10
SKIP=4
LGRT=200
SKIP=8
(STEP 7)
(STEP8)
(STEP 7)
(STEP8)
PNL=0
OVFT=0
PNL=128 OVFT=0
Advertisement
Table of Contents
