Figure 5-22 Actk Command Display (Example); Figure 5-23 Mounting Fch And Dti Cards In Regular Density Slots - NEC NEAX 2400 IMX Manual

DATA PROGRAMMING
Assignment of Telephone Numbers
STEP 2: ACTK
Assign the connection trunk data of both B-channel and D-channel using the ACTK command. As-
sign the Connection Equipment Number (C_LENS) referring to
The ACTK command display should look similar to the following.
ACTK (Assignment of Connection Trunk Data for Local Data Memory)
C_RT
C_TK
10
1
C_LENS
000010
WRT?
Y
The mounting location of the FCH, DTI cards can be classified into the following two types.
Regular Density Slot (16-port slot) -See
High Density Slot (32-port slot) -See
6.1.1 When FCH is mounted in a Extended Density Slot
If the FCH is to be mounted in the Extended Density Slot, the connection trunk should be assigned as
shown in the figures below. If the card's mounting location is in any of the Slot Nos. 04, 06, 08, or 15,
17, 19, the following extended Group should be used for the Dch trunk: G27, 29, or 31.
shows an example where the cards are mounted in density Slots 04 or 05.
02 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23
00
example

Figure 5-23 Mounting FCH and DTI Cards in Regular Density Slots

CHAPTER 5
Page 76
Revision 3.0

Figure 5-22 ACTK Command Display (example)

Figure
Figure 5-24
15 19
07
05 09 11
14 18
21
13 17
04 06 08
10
12 16 20
32 Port
16 Port
FRONT VIEW
ND-70185 (E)
Get other manuals https://www.bkmanuals.com
Figure 5-22
C_RT: Connection Route (1-1023)
C_TK: Connection Trunk (1-4095)
C_LENS: Connection Line Equipment Numbers
5-23.
and Figure 5-25.
23
01 07
03 05
22
00 02 04
06
16 Port
through Figure 5-25.
Figure 5-23
15
19 23
09 11
14 22
18
PIM
13 21
17
08
10
12
16 20
32 Port