NEC NEAX 2400 IMX Manual page 73

Fusion network system
Hide thumbs Also See for NEAX 2400 IMX:
Table of Contents

Advertisement

DATA PROGRAMMING
Network Data Programming Summary
1. Network Data Programming Summary
This section explains a summary of the data programming of Fusion systems.
1.1 Brand-new Fusion Network
To install the Fusion network as a brand-new system, the overall data programming procedure is as follows.
1.1.1
System Data
Decide an NCN, and LN on the network.
Assign System Data for each node. Use the ASYDN command for the NCN and the ASYDL com-
mand for all nodes. The system data includes the size of LDM, NDM, Fusion Point Code (FPC), etc.
The data becomes effective by executing "Non-Load Initial" after setting the FPC.
Note:
Assign unit data using the AFMU command for each node which exists on the network. Note that
the AFMU command is available at NCN only.
Assign Logical Route Numbers for all routes (external trunk) on the network using the ALRTN
command. Note that the ALRTN command is available at NCN only.
1.1.2
Numbering Plan Data
ANPDN → ASPAN (for NCN only): Assign numbering plan data for Telephone Number.
ANPDL → ASPAL (for NCN and LN): Assign numbering plan data for Service Codes, Trunk Ac-
cess Codes, etc. other than STN (physical station) and TELN.
ANPD → ASPA (for NCN and LN): Assign numbering plan data for Physical Station Number
using STN.
Note:
The Numbering Plan data for the LDM and/or NDM cannot use separate Tenant Numbers (TN). Therefore,
be sure to assign the following data on the ASYDL command.
ASYDL command, SYS1, INDEX 800
b1 = 1 (ASPAL command tenant data table development on LDM = Common)
b2 = 1 (ANPDL command tenant data table development on LDM = Common)
1.1.3
Station Numbering
Assign Telephone and/or Physical Station Numbers using the following command:
ALGNN → ALGSN: Assign Telephone Number on the network. (NCN only)
ASDT: Assign Physical Number for each node as required. (available for NCN and LN)
1.1.4
Fusion Link Data
Assign the Fusion Link data using the following commands:
Fusion with FCH:ACRD → ACTK → ACAN → MBCT → AFCH → AFPC → AFRT
Fusion w/o FCH:ACRD → ACTK → ACAN → MBCT →
CHAPTER 5
Page 58
Revision 3.0
ND-70185 (E)
Get other manuals https://www.bkmanuals.com
AFPC

Advertisement

Table of Contents
loading

Table of Contents