NEC NEAX 2400 IMX Manual page 211

EX- FCCS
Data Programming
2. To Access EX-FCCS Trunk via EX-FCCS Telephone Number
Assign the following data at NCN of the FUG.
STEP 1: AEADN
Assign the ADC (Abbreviate Digit Code) for connection Fusion Group. Enter the FUG Number as-
signed by AFUGN command, TN, and ADC to be assigned.
STEP 2: AELGN
Telephone Numbers must be assigned for all the station within the network uniquely. Use AELGN
command to allocate EX-FCCS Telephone Number. FUG data must be assigned previously by
AFUGN command to activate this command.
Only readout function can be used by this command in case both the Self FUG Number and the Con-
nection FUG Number are assigned, if the Self FUG is not the Center FUG.
Check whether the trunk originating call via CCIS can be executed by dialing EX-FCCS Telephone Number
Note 1:
here. Reexamine the assigned data if the call cannot be connected. There may be some error in data setting
so far.
Refer to the service feature manual for NEAX2000 IVS
Note 2:
2
IVS side.
4.2.3 Upgrading CCIS Network including IVS
CCIS
CCIS
CCIS
CCIS
CHAPTER 8
Page 196
Revision 3.0
2
system as to the data programming on NEAX2000
2
System to EX-FCCS Network
FUG2
IMX
PC2
NCN2
FUG3
IMX
PC3
NCN3
ND-70185 (E)
Get other manuals https://www.bkmanuals.com
FUG1
(Center FUG)
IMX
Enhanced
CCIS
PC1
NCN1
Enhanced
CCIS
2
IVS System
PC4
Enhanced
CCIS
Enhanced
CCIS
PC5
2
IVS System