Figure 5-31; Figure 5-32 Afpc Command Display (Example) - NEC NEAX 2400 IMX Manual

DATA PROGRAMMING
Assignment of FCH Related Data
STEP 3: AFPC
Assign FCH routing data using the AFPC command. A maximum of 8 connection routes and FCHN/
FPCN can be assigned on a node basis. FCHN is used for Fusion System with FCH. FPCN is used
for Fusion System without FCH. The list box labeled FCH on the AFPC command determines the
system type. Assign "0" for Fusion System without FCH and "1" for Fusion System with FCH. In
this step, the explanation is given using the following network as an example.
sample Fusion network. Each number in the circle represents the Fusion Point Code (FPC).
This figure shows an example of Fusion network. Each number in the circle stands for Fusion Point Code (FPC).
NCN: Network Control Node
LN: Local Node
The AFPC command display (Fusion with FCH) should look similar to the following:
AFPC (Assignment of FCCH Routing Data for Local)
For Help, press F1
The AFPC command affects communications between nodes. Change the data
WARNING:
with extreme care.
CHAPTER 5
Page 84
Revision 3.0
Node A
10
1
NCN
LN
FCHN=1
12
LN
Figure 5-31 Fusion Network (example)
Assign Destination FPC (far end FPC).
FPC
FCCH
0: Fusion without FCH / 1: Fusion with FCH
22 1
CNT C_RT
FCHN/FPCN
1
10
2
3
4

Figure 5-32 AFPC Command Display (example)

ND-70185 (E)
Get other manuals https://www.bkmanuals.com
Node C
21
11
LN
LN
C_RT=10 Node B
LN 24
Node F
FCH number (1-255)
CNT C_RT
FCHN/FPCN
5
6
7
8

Figure 5-31

shows a
LN
LN
22
2
Node D
23 LN
Node E