Table of Contents
Advertisement
STEP 4: MBCT
Unbusy the connection trunk data assigned in the previous step using MBCT (Make Busy of Connec-
tion Trunk) command. This step is required for both B-channel and D-channel trunk. The MBCT
command should look similar to the following.
MBCT (Make Busy of Connection Trunk for Local)
C_RT
1
MB
0
WRT?
Y
7. Assignment of FCH Related Data
STEP 1: For Fusion with FCH only:
•
Assign FCH Number on an FCH (PA-FCHA) circuit card basis.
•
The FCH Number must conform to the following conditions:
•
FCH Number range must be between 1 and 255.
•
At the network level, the same FCH Numbers can be assigned. However, they must be unique at the
node level.
•
Use sequential numbers starting from 1 as FCH Numbers.
C_TK
5
Figure 5-26 MBCT Command Display
ND-70185 (E)
Get other manuals https://www.bkmanuals.com
Assignment of FCH Related Data
MBCT (Make Busy of Connection Trunk Data)
C_RT: 1-1023
C_TK: 1- 4095
Make Busy Information
0: Make Idle
1: Make Busy (Outgoing)
DATA PROGRAMMING
CHAPTER 5
Page 81
Revision 3.0
Advertisement
Table of Contents
