Table of Contents
Advertisement
Chapter 2 Preparations
Installing a PCI board into the Tertiary riser card Slot3
This server supports Slot 3 (low-profile PCI board enabled) by the Tertiary Riser card.
Please prepare T-10 hexalobular driver before installation.
See supported PCI boards and mountable slots and confirm the installation location and PCI boards.
To install PCI board, follow these steps.
1.
Back up all data in the server.
2.
See steps 1 to 6 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
3.
Lift up the bracket of slot3 on the secondary riser card.
・Low profile
(1)
Lift up the low-profile bracket in Slot 3 of riser card.
(2)
Take off the screw and remove the blank cover.
Important
When installing a PCI card, make sure the connector of the card fits the
connector of the riser card.
Note
Check the card type (Low Profile or Full Height) which respective riser card
supports and the type of PCI card to be installed.
Express5800/R120h-1M User's Guide
1. Installing Internal Optional Devices
105
Advertisement
Table of Contents
