Table of Contents
Advertisement
Chapter 3 Setup
Category
Enable X2APIC
Boot
feature
your OS.
Security
Set a password
Restrict bootup by
entering password
To make Intel(R)
TXT(Trusted
Execution
Technology), which is
needed for
tboot(Trusted Boot),
enabled
UPS
When the server is
Powerlink
supplied with power
from UPS, always turn
on the power.
If it is turned off by
using POWER switch,
leave it OFF even
when UPS supplies
power.
Keep the power OFF
even when UPS
supplies power.
*1 The factory setting is that "the Boot Mode menu" is set as "UEFI" and "the X2APCI menu" is set as "Enabled".
198
Description
Advanced > Processor Configuration > X2APIC >
according to
Disabled *1
・Disable X2APIC for the following OS.
－ Windows Server 2012 R2
－ Windows Server 2016
－ VMware ESXi 6
－ VMware ESXi 6.5
Set your password in System Configuration >
BIOS/Platform Configuration (RBSU) > Server
Security - Set Admin Password
Set your password in System Configuration >
BIOS/PlatformConfiguration (RBSU) > Server
Security using Set Power On Password
Install optional TPM kit and set to Enabled in
System Configuration > BIOS/Platform
Configuration (RBSU) > Server Security - Intel
(R) TXT Support.
Set to Always Power On in System
Configuration > BIOS/Platform Configuration
(RBSU) > System Options > Server Availability
- Automatic Power-On
Set to Restore Last Power Stats in System
Configuration > BIOS/Platform Configuration
(RBSU) > System Options > Server Availability
- Automatic Power-On
Set to Always Power Off in System
Configuration > BIOS/Platform Configuration
(RBSU) > System Options > Server Availability
- Automatic Power-On
Express5800/R120h-1M User's Guide
To be changed
2. Description on System Utility
(3/3)
Remark
The setting must be done in
compliance with the
checklist before setup in the
installation guide of your OS
For Windows: [Chapter 1
Installing Windows]
If you set your password,
your are prompted to enter
the password from the next
time you start System Utility
If you set your password,
your are prompted to enter
the password from the next
time you start the system
Do not disable TPM with the
TPM management module
after setting [TXT Support]
to [Enabled] to start OS.
You may not be able to
change [TPM Support] and
[TXT Support].
In that case, execute [F7:
Load Defaults].
If you connect UPS via
RS232C, make console
redirection setting invalid
from System Utility (set to
Disabled in BIOS Serial
Console Port).
Advertisement
Table of Contents
