Table of Contents
Advertisement
Chapter 2 Preparations
5.
Connect the DisplayPort/USB cable to the DisplayPort/USB connector on the rear in a routing shown below.
6.
See Chapter 2 (1.26 Installing Top Cover) to attach the top cover of the server.
7.
Please see Chapter 2 (2 Installation and Connection) in this manual to conduct installation and connection,
and turn the power supply ON.
Installing the optical disk drive N8151-137/ 138
Before installing this optional optical disk drive, the Built-in DVD Drive Expansion Kit must have been installed.
Please prepare the following before installing the option.
Parts included in the option kit
T-10 hexalobular driver
DVD-ROM drive (N8151-137), or DVD-Dual drive (N8151-138)
To install the components, follow these steps.
1.
Back up all data in the server.
2.
See steps 1 to 6 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
134
Note
In order to prevent damage of the system due to improper cooling or elevated
temperature, please do not activate the server or enclosure without implementing
any of component or blank on all of drive bays and device bays.
Note
In order to prevent the damage to electronic components, please start to install the
system after conducting the appropriate anti-static treatment. There is a possibility
of causing electrostatic discharge if appropriate grounding wire treatment is not
conducted.
Express5800/R120h-1M User's Guide
1. Installing Internal Optional Devices
Advertisement
Table of Contents
