Table of Contents
Advertisement
Chapter 2 Preparations
Attaching the outer rail to the rack
Insert the round protrusion on the outer rail into the square hole of the 19-inch rack. Make sure that it
makes a clicking sound indicating that it is locked.
The figure on left shows the front side of the right outer rail. The figure on right shows the rear side of the
right outer rail.
Install the left outer rail in the same way.
Make sure that the rail is installed at the same height as the other rail already installed.
The front side of the right
outer rail
Removing the outer rails
Remove outer rails from the rack in the following procedure.
See Chapter 2 (2.1.7 Installing the server to the rack or removing it from the rack, (2) Removal
procedure) to remove the server from the rack.
1.
Reduce the slide rail of the outer rail. In case the slide rail is locked in the middle, continue pushing
the rail stopper on the side of the rail to reduce the slide rail.
2.
Push the slotted screwdriver into the unlocking hole on the front side of the outer rail, and move it in
the direction of the arrow to release the lock, then push the rail forward to remove it.
172
Important
Confirm that the rail are securely locked so that they will not fall off.
Tips
Although the rail may be somewhat unsteady, it is not defective.
Express5800/R120h-1M User's Guide
2. Installation and Connection
The rear side of the right
outer rail
Advertisement
Table of Contents
