Table of Contents
Advertisement
Chapter 2 Preparations
Open the lids of the unit fixing screws on both sides of the device. Then remove the fixing screws
inside with hexalobular driver, if the device is screwed on. If the device is not screwed on, you can
unlock the device just by opening the lid.
Slide the unit forward, and remove from the rack while holding it securely. In case the unit is locked in
the middle, continue pushing the rail stopper on the side of the rail and slowly draw out the unit to
remove from the rack.
(b) Slide rail for 1U rack server N8143-127/128
1) Installation
Mount the server to a rack in the following procedure.
1.
Pull out the left and right outer rails until they are completely locked to the front side.
2.
Hold the unit securely by two or more persons, and lift it to the height of the rack rail.
176
Important
Be careful not to get your fingers caught in the rails or lever.
While more than one person is supporting the bottom part of the server,
Important
slowly pull out the server.
Do not apply pressure on the server from top when it is being pulled out.
Doing so cause the server to drop.
Important
Always install the server with two or more persons.
Express5800/R120h-1M User's Guide
2. Installation and Connection
Advertisement
Table of Contents
