Table of Contents
Advertisement
Chapter 2 Preparations
Installing primary GPU and cable options
Please use standard primary riser card to install this GPU option.
Please check if the capacity of power unit is enough before installing this option.
Please prepare the following before installing the option.
Parts included in the option kit
Cable
To install the components, follow these steps.
1.
Create back up data of all data in the server.
2.
See steps 1 to 6 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
3.
Pick up the both end part of the primary riser card and lift them up to remove.
4.
Fix GPU on the x16 lane connector of the primary riser card, and in case GPU needs more than 75W of
electricity, connect a power cable to GPU and the riser card.
Slot 1
Important
The surface becomes hot after use so to avoid burns please allow the drive
and internal parts of the system to cool before touching.
Note
In order to prevent the damage to electronic components, please start to install the
system after conducting the appropriate anti-static treatment. There is a possibility
of causing electrostatic discharge if appropriate grounding wire treatment is not
conducted.
Express5800/R120h-1M User's Guide
1. Installing Internal Optional Devices
X16 lane connector
87
Advertisement
Table of Contents
