Table of Contents
Advertisement
Chapter 2 Preparations
Installing Primary Riser Card
Please prepare the following before installing the options.
Parts included in the option kit
To install the components, follow these steps.
1.
See steps 1 to 6 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
2.
Raise the screw handles located on the upper part of the riser card and turn it 180° to the left. Then, pull
the riser card up to remove it.
3.
Adjust the position of the riser card edge of the riser card to the position of the connector, and push it in
place from above.
Raise the screw handles at the top of riser card, turn the screws to the right 180 degrees while pressing
them down. Then, after fixing the riser card, put down the screw handles as before.
4.
See Chapter 2 (1.34 Installing Top Cover) to attach the top cover of the server.
94
Note
In order to prevent the damage to server's main body or the expansion board,
please remove all the AC power cables before removing/installing riser card.
Note
In order to prevent damage of the system due to improper cooling or elevated
temperature, please do not activate the server or enclosure without implementing
any of component or blank on all of drive bays and device bays.
Express5800/R120h-2M (3rd-Gen) User's Guide
1. Installing Internal Optional Devices
Advertisement
Table of Contents
