Table of Contents
Advertisement
Chapter 3 Setup
□ <F12> key
The following screen is displayed. If you choose Yes, the parameter you set is saved and then a message
urging to reboot is displayed.
If you select Reboot, the device restarts.
□ Operation for a restart of iLO in "BMC Configuration Utility" of System Utilities
When saving settings after a setting change in "BMC Configuration Utility" of System Utilities, a restart of
iLO may be required. In this case, perform the following steps.
* If you fail to follow this procedure, a stall may occur during a system reboot that follows, or setting
information such as serial numbers and product IDs recorded on the system may be lost.
(1)
When settings are changed in "BMC Configuration Utility" of System Utilities, the Warning pop-up shown
below may be displayed to restart iLO.
(2)
Click OK to proceed.
Express5800/R120h-2M (3rd-Gen) User's Guide
2. Description on System Utility
237
Advertisement
Table of Contents
