Table of Contents
Advertisement
Chapter 2 Preparations
5.
If you like to install the included cable tie strip to the rear side of the rack, attach the tie strip to the
mounting hole of the outer rail as shown below.
6.
If you like to secure the unit to the rack with screw, open the lid of the edge part of the unit and fasten
the Hexalobular screw inside with a Hexalobular screwdriver to secure the unit to the rack.
(b) Removal procedure
Remove the server from the rack in the following procedure.
Make sure that the server is turned off and then disconnect the power cord or all interface cables from
the server.
Remove the front bezel.
Important
At least two persons are required to remove the server from rack.
Express5800/R120h-2M (3rd-Gen) User's Guide
2. Installation and Connection
219
Advertisement
Table of Contents
