Table of Contents
Advertisement
Chapter 2 Preparations
5.
Fit the riser card edge of primary riser card to the position of connector and push the edge into the connector
from above. Raise the screw handles at the top of riser card, turn the screws to the right 180 degrees while
pressing them down. Then, after fixing the riser card, put down the screw handles as before.
6.
See Chapter 2 (1.34 Installing Top Cover) to attach the top cover of the server.
7.
Please see Chapter 2 (2 Installation and Connection) in this manual to conduct installation and connection,
and turn the power supply ON.
Removal
The procedure for removal is the reverse of installation.
100
Note
In order to prevent damage of the system due to improper cooling or elevated
temperature, please do not activate the server or enclosure without implementing
any of component or blank on all of drive bays and device bays.
Express5800/R120h-2M (3rd-Gen) User's Guide
1. Installing Internal Optional Devices
Advertisement
Table of Contents
