Table of Contents
Advertisement
Chapter 2 Preparations
5.
Bring the 2x 2.5-inch drive cage out from the optional kit, attach rubber bushes on four slotted holes, install
it through the inside to the outside of the housing, and secure with the screws (x4).
6.
Attach a drive or a dummy tray to the drive cage.
7.
If you removed a riser card in the step2, fit the terminal of riser card to the slot on the mother board and
insert the terminal firmly into the slot. Then fix the riser card. Next, raise the screw handle at the top of cage
and turn the handle to the right 180 degrees to fix the cage. Then put down the screw handle as before. If
you removed a blank cover in step2, insert the cover from the upward direction and secure it with the screws
(x2).
Express5800/R120h-2M (3rd-Gen) User's Guide
1. Installing Internal Optional Devices
169
Advertisement
Table of Contents
