Installing The Riser Card - NEC Express5800 Series User Manual

Chapter 2 Preparations
1.10.3

Installing the Riser Card

Reverse procedure to removing the Riser Card for installing the Riser Card.
Remove the blank cover if it's on the position of 1
Adjust the position of the Riser Card edge of the Riser Card to the position of the connector, and push it in place
from above.
Raise the screw handles at the top of Riser Card, turn the screws to the right 180 degrees while pressing them
down. Then, after fixing the Riser Card, put down the screw handles as before.
・1st Riser Card
Note
In order to prevent damage of the system due to improper cooling or elevated temperature,
please do not activate the server or enclosure without implementing any of component or
blank on all of drive bays and device bays.
Keep each removed blank covers.
Note
Express5800/R120h-2E User's Guide
st nd
Riser Card or 2 Riser Card.
1. Installing Internal Optional Devices
85