Raid Controller N8103-189/190（Aroc Type-A; Install - NEC Express5800 Series User Manual

Chapter 2 Preparations
1.13
RAID Controller N8103-189/190（AROC Type-a）
This server supports RAID controller PCI board dedicated slot.
1.13.1

Install

Please prepare the following before installing the option.
 Parts included in the option kit
 T-10 hexalobular driver
To install the components, follow these steps.
1. Make sure that the following requirements are met.
● Be sure to install the additional battery (N8103-198) for the RAID controller when implementing the
RAID controller (N8103-190/201) equipped with the FBWC function.
● When you connect a cable, connect it to a connector of parts following the direction of label attached
to the cable.
Check that the versions of firmware of RAID Controller and SAS Expander are the latest.
●
To download the latest firmware, visit NEC web site.
2. See steps 1 to 7 in Chapter 2 (1.2 Overview of Installation and Removal) for preparations.
3. See Chapter 2 (1.10 Riser Card) to remove the Riser Card.
102
The surface becomes hot after use so to avoid burns please allow the drive and
Important
internal parts of the system to cool before touching.
In order to prevent the damage to electronic components, please start to install the
Note
system after conducting the appropriate anti-static treatment. There is a possibility
of causing electrostatic discharge if appropriate grounding wire treatment is not conducted.
Express5800/R120h-2E User's Guide
1. Installing Internal Optional Devices
RAID controller PCI board dedicated slot