Enable Tpm; Notes On Windows Bitlocker - NEC Express5800 Series User Manual

Chapter 2 Preparations
8. Please see Chapter 2 (2. Installation and Connection) in this manual to conduct installation and
connection, and turn the power supply ON.
1.7.2

Enable TPM

The server will restart twice without user input. TPM setting is enabled after restarting and POST is complete.
You can now make use of Microsoft Windows BitLocker using TPM and major boot etc. according to above.
If you need detailed information on the update of firmware and the procedure of hardware, refer to the Web Site
of NEC Support Center.
For more information about how to configure the TPM to using BitLocker, see the Microsoft Web site.
1.7.3

Notes on Windows BitLocker

When you set up BitLocker, a recovery key/password will be generated. Once BitLocker has been enabled,
you can save and print them.
Please keep the recovery key/password when using BitLocker. When BitLocker detects the system integrity
may be compromised the recovery/password is necessary for recovery mode.
To ensure security, please keep the recovery key/password information according to the following guidelines.
 Be sure to store in multiple locations.
 Store away from the machine.
Do not store on a BitLocker encrypted hard disc drive.

58
Important
TPM Kit once installed cannot be removed.
Ask your sales representative if you want to remove the TPM kit.
Note
When enabling TPM, and operating it as below please follow the appropriate steps.
Data access will be blocked if the operation is incorrect.
Updating system and firmware of options
・
Replacing system board
・
Replacing hard disk drive
・
Modifying OS application TPM settings
・
Express5800/R120h-2E User's Guide
1. Installing Internal Optional Devices