Removing and installing components
NOTE:
The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Plastic scribe
Screw list
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE:
Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE:
Screw color may vary with the configuration ordered.
Table 1. Screw list
Component
Base cover
Wireless card
M.2 2230 solid-state drive
M.2 2280 solid-state drive
Assembly inner frame
4-cell battery
Heat sink with fan assembly -
UMA
Heat sink with fan assembly -
Discrete
10
Removing and installing components
Screw type
Captive screws
Captive screws
M2x3
M2x3
M2x3
M2x5
M2x3
● M2x3
● M2x5 (for fan)
● M2x3
● M2x5 (for fan)
Quantity
8
1
4
2
7
2
2
● 4
● 2
● 6
● 2
2
Screw image
N/A
N/A
●
●
●
●