Locking System & Replacing The Lock Cylinders - Siemens SICHARGE D Operating Instructions Manual

3.5.10 Locking system & replacing the lock cylinders
The door locks and the door opener secure access to the inside of the charging station.
Monitoring of the doors
The position switches on the doors detect whether the doors are closed. If the doors are
opened without authorization during operation despite the lock system, the emergency stop
is triggered. The circuit breaker opens automatically and interrupts the power supply to the
power strings. Power supply to the controller is maintained.
Shut down the charging station before opening a door. The shutdown process is described in
the section "Switching off the charging station (Page 108)".
Door and locking cylinder, front
At the front, the lock cylinder is in the cover at the top left next to the device door.
Figure 3-5 Lock cylinder, front
To maintain the industrial security concept, replace the supplied locking cylinders with your
own standard half cylinders (10/30) according to DIN 18252.
1. Unlock the lock. Remove the cover by pressing the cover upwards.
Press the button under the cover to open the door.
2. Remove the fixing screw on the rear.
3. Remove the locking cylinder.
Install your own locking cylinder in the reverse order. The maximum torque of the fixing
screw is 2.5 Nm. Then mount the cover back on the charging station.
SICHARGE D
Operating Instructions, 11/2023, A5E50556539-AG
3.5 Display elements and operator controls
Description
37