Siemens SICHARGE D Operating Instructions Manual page 88

Installation and mounting
5.5 Setting up the charging station
5. Position the cover plate so that the four threaded bolts pass completely through the holes
of the fan cover plate. Screw in the cover plate with four M8 hex nuts.
Figure 5-14 Screwing down the fan cover plate
6. Tighten the bolts and nuts according to these instructions:
– M12x30 hexagon screw: Wrench width 19 mm, the tightening torque is 46 Nm.
– M6 hexagon nut: Wrench width 10 mm, the tightening torque is 8 Nm
– M8 hexagon nut: Wrench width 13 mm, the tightening torque is 13 Nm
If you operate the charging station in accordance with German calibration law, then seal the
cover plate with sealing stickers
Figure 5-15 Sealing sticker
88
When tightening, make sure that the bezel brackets do not twist.
①
on the cover plate
①
.
Operating Instructions, 11/2023, A5E50556539-AG
SICHARGE D