Table of Contents
Advertisement
NOTE:
Temporarily label each MicroSD card with its corresponding slot number after removal.
Next steps
1
Follow the procedure listed in
2
Install a MicroSD card.
Installing the MicroSD card
Prerequisites
Follow the safety guidelines listed in
NOTE:
To use an MicroSD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
NOTE:
If reinstalling, ensure that you install the MicroSD cards into the same slots based on the labels you had marked on the
cards during removal.
Steps
1
Locate the MicroSD card connector on the IDSDM/vFlash module. Orient the MicroSD card appropriately and insert the contact-pin
end of the card into the slot. To locate IDSDM/vFlash, see the
NOTE:
The slot is keyed to ensure correct insertion of the card.
2
Press the card into the card slot to lock it into place.
Next step
Follow the procedure listed in
Removing the optional IDSDM or vFlash card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
If you are replacing the IDSDM/vFlash card, remove the MicroSD cards.
NOTE:
Temporarily label each MicroSD card with its corresponding slot number after removal.
Steps
1
Locate the IDSDM/vFlash connector on the system board.
To locate IDSDM/vFlash connector, see the
2
Holding the pull tab, lift the IDSDM/vFlash card out of the system.
118
Installing and removing system components
After working inside your
Safety
instructions.
After working inside your
system.
Safety
instructions.
After working inside your
System board jumpers and connectors
system.
System board jumpers and connectors
system.
section.
section.
Advertisement
Table of Contents
