Figure 100. Installing the USB module
Next steps
1
Install the air
shroud.
2
Install the backplane
cover.
3
Follow the procedure listed in
VGA module
Removing the VGA module
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove the front bezel
4
Remove the backplane
5
Remove the air
shroud.
6
Disconnect the VGA cable from the VGA connector on the system board. For locating the connector, see the
and connecters
section.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route these cables properly
when you replace them to prevent them from being pinched or crimped.
Steps
1
Using Phillips #1 screwdriver, remove the screw on the VGA module.
2
Slide the module out of the system.
148
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
cover.
system.
system.
System board jumpers