Installing the NVDIMM-N battery
Prerequisite
1
Follow the safety guidelines listed in
CAUTION:
off before removing the NVDIMM-N battery.
CAUTION:
removing a battery.
Steps
1
Holding the edges, align the NVDIMM-N battery with the battery connector on the system board
2
Connect the cables to the NVDIMM-N battery.
3
Using the Phillips #2 screwdriver, tighten the screw to secure the NVDIMM-N battery.
Figure 37. Installing the NVDIMM-N battery
Next step
1
Follow the procedure listed in
Processors and heat sinks
Removing a processor and heat sink module
Prerequisites
WARNING:
The heat sink may be hot to touch for some time after the system is powered down. Allow the heat sink to cool
before removing it.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
If applicable,
remove the air shroud.
Safety
instructions.
To prevent data loss, ensure that your system and LEDs on NVDIMM-N and NVDIMM-N battery are turned
To avoid damage to the battery connector, you must firmly support the connector while installing or
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
93