Next steps
1
Reconnect all the disconnected cables to the rear drive backplane.
2
Install all the drives.
3
Follow the procedure listed in
System battery
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. For more information, see the safety information that shipped with your
system.
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
If applicable, disconnect the power or data cables from expansion card(s) in the expansion card riser 1A.
4
Remove the low profile or full height X1 expansion card riser
Steps
1
Locate the battery socket.For more information, see the
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing or
removing a battery.
2
Use a plastic scribe to pry out the system battery.
Figure 97. Removing the system battery
3
To install a new system battery, hold the battery with the positive side facing up and slide it under the securing tabs.
4
Press the battery into the connector until it snaps into place.
Figure 98. Installing the system battery
After working inside your
system.
Safety
instructions.
Before working inside your
System board jumpers and connectors
system.
1A.
Installing and removing system components
section.
145