Figure 92. Cable routing - 8 x 2.5 drive backplane with onboard SATA
1
drive backplane
3
backplane signal cable(BP: J_BP_SIG to MB: J_BP_SIG1)
5
system board
7
cable routing clip
SAS expander card
Removing the SAS expander card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove the cooling
shroud.
4
Remove the cooling fan assembly.
5
Remove the backplane
6
Disconnect the SAS cables from the SAS expander card.
Steps
1
Using Philips #2 screwdriver, loosen the screws that secure the SAS expander card to the expander card tray.
2
Pull the SAS expander card to disengage the connectors on SAS expander from the SAS connectors on backplane.
Safety
instructions.
Before working inside your
cover.
2
cable routing clip
4
backplane power cable(BP: J_BP_PWR_A1 to MB: J_BP1)
6
SATA cable(BP: J_SAS_A0, J_SAS_B0 to MB: SATA_A,
SATA_B)
system.
Installing and removing system components
141