Installing The Vga Module - Dell 0G8DW Installation And Service Manual

Figure 101. Removing the VGA module
Next step
1 Install the VGA module.

Installing the VGA module

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the front bezel.
4 Remove the backplane
5 Remove the air shroud.
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route these cables
properly when you replace them to prevent them from being pinched or crimped.
Steps
1 Route the VGA cable through the VGA module slot on the front of the system and slide the VGA module into the slot.
2 Align the hole on the module with the screw hole on the system.
3 Using the Phillips #1 screwdriver, secure the VGA module to the system with the screw.
Safety instructions.
Before working inside your
cover.
system.
Installing and removing system components 149