Table of Contents
Advertisement
Steps
1
Align the M.2 SSD module connectors with the connectors on the BOSS card.
2
Push the M.2 SSD module until the module is seated firmly on the BOSS card.
3
Secure the M.2 SSD module on the BOSS card with the retention straps and screws.
Figure 64. Installing the M.2 SSD module
1
module connector (2)
3
modules (2)
Next steps
1
Install the BOSS card.
NOTE:
Installing the BOSS card is similar to installing the expansion card riser.
2
Install the air
shroud.
3
Follow the procedure listed in
Optional IDSDM or vFlash module
NOTE:
The write-protect switch is on the IDSDM or vFlash module.
Removing the MicroSD card
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Steps
1
Locate the MicroSD card slot on the vFlash/IDSDM module, and press the card to partially release it from the slot. To locate IDSDM/
vFlash module, see the System board jumpers and connectors section.
2
Hold the MicroSD card and remove it from the slot.
After working inside your
system.
Safety
instructions.
Before working inside your
2
screws (2)
system.
Installing and removing system components
117
Advertisement
Table of Contents
