Test Setup
HP 8117A
Procedure
1. Connect the equipment as shown in the setup figure. Use a
50 CR feedthrough termination if you cannot select 50 R input
impedance on the counter.
2. Set up the HP 8112A as follows:
Input Mode
Control Mode
Transition
D T Y
HIL
3. Set the counter as follows:
TIME
Slopes A and B
Trigger levels
Gate Mode
4. Set the HP 8112A Delay and Period to the following values and
read the actual output from the counter. Record your results on a
copy of the Test Record, specified limits are given here and on the
Test Record.
Figure 8-2. Delay Performance Test
NORM
Off
Fixed
50%
2.40 V
0.00 v
Positive
1.2 v
HP 8112A
Counter reading
setting
D E L
PER Low Limit High Limit
75 ns
95 ns
50 ps
95 ps
47.50 ps
10 ms
95 ms
900 ms 950 ms 855.0 ms
Counter (HP 5335A)
ns
83.75
52.50 ps
10.50 ms
945.0 ms
Testing Performance 8-5