Selecting Control Mode; Control Input; Relationship Between Control Input Voltage And - HP 8112A Operating, Programming And Servicing Manual

Selecting Control
Mode
8112A PULSE GENERATOR SOMHz

Control Input

Caution
0 Pmc
0 UIDC
c l
Figure 4-4. Control mode controls
An analog signal can be applied to the control .input to modulate or
control the HP 8112A output signal. This external input may be any
waveform in the range f20 V. However, the overall range within
which the instrument actually responds to a control signal, is 1.0 V
to 10 V, as shown below.
Do not apply voltages outside the range f20 V to the CTRL INPUT
connector.
C T R L
I N P U T
Figure 4-5. Relationship Between Control Input Voltage and Controlled Parameter
PERIOD, WIDTH and DELAY
1 ms 10 ms
100 ms
Operating 4-7
1 5