Setting Parameters; Selection; Adjustment; Period/Burst Key - HP 8112A Operating, Programming And Servicing Manual

Setting Parameters

8112A PULSE GENERATOR 50MHz

Selection

Adjustment

Period/Burst Key

O V I D o L B
q q q q q pJ q us 1 0 "RCL
Figure 4-10. Parameter controls
The parameters available for selection depend on the currently
selected modes. All parameters are described below.
Pressing a parameter key selects the parameter indicated by the
illuminated mnemonic above the key.
The current value of the selected parameter is shown on the digital
display. The parameter units are indicated by the LEDs to the right
of the display.
The currently selected parameter is adjusted uSsing the [VERNIER]
corresponding digit in the digital display. Similarly, the (RANGE) key
increases or decreases the parameter value by a factor of 10.
[PER)
When selected, allows the period of the HP8112A output signal to be
set and or adjusted.
In EBUR mode, this key is used to set the number of pulses (between
1 and 1999) which will comprise the burst.
- V E R N I E R
3 3
El
key increments or decrements the
Operating 4-13
and