JUPITER-(3000K, 6000K, 9000K)-H1 Smart
Transformer Station
User Manual
Figure 6-45 Removing the heater
Step 4 Install a new heater in the original position. Use an M6 Phillips screwdriver and
tighten the screws to a torque of 5 N·m.
Step 5 Reconnect the cables to the new heater based on the cable connection records.
Use an M3 Phillips screwdriver and tighten the screws to a torque of 0.5 N·m.
Step 6 Reinstall the sealing plate to the LV panel. Use an M6 Phillips screwdriver and
tighten the screws to a torque of 5 N·m.
Step 7 Power on the heater in the reverse order of powering off the heater.
----End
6.8.14 Replacing T/H Sensors
6.8.14.1 Replacing a T/H Sensor in the LV Panel
Context
If a T/H sensor is found damaged during maintenance, power it off and replace it.
Issue 02 (2023-09-30)
NO TE
The appearance of the STS varies with the model, but the installation positions of T/H
sensors are the same. This section uses one type of appearances as an example.
Copyright © Huawei Technologies Co., Ltd.
6 System Maintenance
176