Table of Contents
Advertisement
JUPITER-(3000K, 6000K, 9000K)-H1 Smart
Transformer Station
User Manual
Follow-up Procedure (PV-only Scenario)
Step 1 Log in to the SmartLogger WebUI, choose Maintenance > Software Upgrade,
upload the STS upgrade package, select the device, and upgrade the STS to ensure
that the STS version is the same as the other STS version displayed on the
SmartLogger WebUI. If they are inconsistent, upgrade the software version to
ensure that no alarm indicating inconsistent measurement and control module
software versions is generated.
----End
Follow-up Procedure (LV Coupling Scenarios of PV and ESS)
Step 1 Log in to the SmartLogger WebUI, choose Maintenance > Software Upgrade,
upload the STS upgrade package, select the device, and upgrade the STS to ensure
that the STS version is the same as the other STS version displayed on the
SmartLogger WebUI.
Step 2 On the SmartLogger WebUI, choose Monitoring > STS > Running Param. > O&M
Parameters, and click Start in the row of Controller location detection to detect
the location of the measurement and control module and assign a physical
location to the new measurement and control module.
----End
6.8.16.2 Replacing a Measurement and Control Module in the MV Room
Power-Off
1.
2.
3.
Procedure
Step 1 Open the end door of the MV room.
Step 2 Remove the cables from the measurement and control module and record their
positions.
Step 3 Remove the old measurement and control module in the MV room.
Issue 02 (2023-09-30)
NO TE
Contact the Company's service engineers to obtain the STS software package.
NO TE
Contact the Company's service engineers to obtain the STS software package.
Turn off the general 800 V switch.
Turn off the general circuit breaker 3FB of the auxiliary loop.
Turn off the inverter switch used by the UPS. (This step is optional. Perform
this step when configuring the UPS. Skip this step when only maintaining the
UPS.)
Copyright © Huawei Technologies Co., Ltd.
6 System Maintenance
193
Advertisement
Table of Contents
