Replacing A Main Control Module - Huawei JUPITER-3000K-H1 Smart User Manual

JUPITER-(3000K, 6000K, 9000K)-H1 Smart
Transformer Station
User Manual
Procedure
Step 1 Remove the cables from the T/H sensor and record their positions.
Step 2 Remove the T/H sensor together with the base.
Figure 6-50 Removing the T/H sensor
Step 3 Set the DIP switch on the new T/H sensor.
Table 6-3 DIP switch settings
Toggle
Switch
1
ON
Step 4 Install a new T/H sensor on the base, and install them in the original position.
Step 5 Reconnect the cables to the new T/H sensor based on the cable connection
records.
Step 6 Close the doors.
----End

6.8.15 Replacing a Main Control Module

Context
An STS main control module is found damaged during maintenance.
Step 1 Back up the configuration file.
The JUPITER STS supports two configuration file backup modes:
●
●
Issue 02 (2023-09-30)
Toggle Toggle
Switch Switch 3
2
OFF OFF
Automatic backup
Manual backup
NO TE
If the main control module cannot communicate with the SmartLogger, skip this step. After
replacing the main control module with a new one, set factory parameters.
Copyright © Huawei Technologies Co., Ltd.
Toggle Toggle
Switch Switch
4 5
OFF OFF
6 System Maintenance
Toggle Toggle Switch 7
Switch
6
OFF OFF
180