Select an interface in the Copy Parameters from field.
3
Select the interfaces to which the GARP Timers information is copied in the Copy To
4
fields.
Defining GARP Timers Using CLI Commands
The following table summarizes the equivalent CLI commands for defining GARP timers
as displayed in the GARP Timers page.
CLI Command
garp timer {join | leave |
leaveall} timer_value
The following is an example of the CLI commands:
Console (config)# interface ethernet 1/e8
Console (config-if)# garp timer leave 900
Configuring the Spanning Tree Protocol
The Spanning Tree Protocol (STP) provides a single path between end stations on a Layer 2
network, thereby eliminating loops.
Loops occur when alternate routes exist between hosts. Loops in an extended network may
cause bridges to forward traffic indefinitely, resulting in increased traffic and a reduction in
network performance. To open the Spanning Tree page:
•
Click Switch > Spanning Tree in the Tree View. The Spanning Tree page opens.
Description
Sets the GARP application join, leave, and
leaveall GARP timer values.
Configuring Switch Infor mation
239