Dell PowerConnect 3324 User Manual page 66

Enter the command interface ethernet at the console to enter the Device
4
Configuration screen mode through VLAN1 as follows:
console> enable
console# configure
console(config)# interface vlan 1
console (config)# exit
Define an IP address on the device by assigning an IP address to the interface
5
connected to the management station (in this example 50.1.1.1). If the management
station is connected directly to the interface, the IP address on the interface must have
the same subnet as the management station.
console> enable
console# configure
console(config)#
console(config-if)# ip address 50.1.1.2 /8
01-Jan-2000 01:48:37 %LINK-W-Down:
console(config-if)# exit
console(config)# exit
If the management station is not directly connected to the interface, that is a member
6
of a remote network, define a default gateway on the device. The gateway configured
IP address is the router interface IP connected to the device.
console> enable
console# configure
console(config-if)#
console(config-if)# exit
console(config)# ip default-gateway 50.1.1.100
console(config)# exit
Ping the management station from device to make sure that connectivity has been
7
achieved (wait 30 seconds for port to be in STP forwarding before doing this).
Management station IP is (in this example) 50.1.1.3:
console> enable
console# configure
console(config)#
66 C o n f i g u r i n g t h e Po w e r C o n n e c t 3 3 2 4 / 3 3 4 8 S w i t c h
Vlan 1